GN 115-WOE-L-NI Zapahi Stainless steel

Lockable latches GN 115-WOE-L lock by a turning operation limited to 90° which moves the latch arm in the locked position behind the door frame. The bevels of the latch arm ease the closing of the door. Thanks to the stainless steel materials used, the latches are optimally suited for use in corrosive environments.

Latch arms are available with different bend angles to cover a latch arm distance A from 4 to 50 mm (version zinc die casting) and from 6 to 50 mm (version stainless steel).

The latches are delivered with 2 keys and loosely enclosed latch arm. The key can be removed in both end positions. The lock is standard, so that every lock can be opened with the same key.

Types with a standard lock allow every lock to be opened with the same key. For the types with different lock, there are more than 200 different lock variants, whose keys are marked by numbers.

• Protective Caps GN 120 (version stainless steel)

• Opening Handles GN 120.1 (version stainless steel)

• Protective Guide Plates GN 120.2

• Sheet Metal Punches GN 123

• Latch arm in A4 (version stainless steel)

• Lock with Different Combinations (version stainless steel)

• List of latch types 

• IP Protection Classes 

• Stainless Steel Characteristics 

For installation, set a hole in the door, cover or hatch as shown in the outline drawing.

Once assembled, the latch is pushed through the bore diameter from the front. The hex nut can then be pushed over the latch from the back and bolted in place.

The required installation bore in the door leaf, is usually generated by punching or laser machining in series production.

The installation bore diameter can also be created by drilling or milling as shown in the outline drawings.

For small series and steel sheets below 2 mm thickness, the sheet metal punches GN 123 are the tool of choice.