Specification
Types
- Type K: With two hand levers and two socket cap screws
- Type S: With four socket cap screws
Mounting clamp
Aluminij
Adjustable hand levers (Type K)
Powder coated
Silver, RAL 9006, textured finish
- Threaded insert and retaining screw
Stainless steel AISI 303
Adjusting wheel
Stainless steel AISI 303
Thrust washer
Plastika
Socket cap screws ISO 4762
Stainless steel AISI 304
- 2x chemically blackened (Type S)
- 2x plain finish (Type K / Type S)
Countersunk screw ISO 14581
Stainless steel AISI 304
Vzmetni
Spring steel AISI 301
Information
Parallel mounting clamps with adjustable spindle GN 474.3 are used for adjusting measuring or test setups.
For coarse adjustments in millimeters, two adjacent clamping points are released so that the rod can be shifted quickly. When using retaining rods / retaining tubes GN 480.1 in type LS with longitudinal scale, their scale provides orientation during presetting.
For fine adjustments, two diagonally opposite clamping points are released. The relative position of the retaining rods/retaining tubes can then be set with the adjusting wheel. The adjusting distance can be read in 0.1 mm increments based on the knurled graduations. Due to the integrated spring, the adjustment is free of backlash.
Adjustment
Line scaling on adjusting wheel for adjustment in 1/10 mm increments
